Contact Us

Shenzhen Runpeng Precision Hardware Co.,Ltd

The contact:Susan Liao

Mobile:86-18925258235

Phone:86-755-29886925 

Fax:86-755-29886926

E-mail:sales@szrunpeng.cn

Web:www.sz-runpeng.com

Add:Building 69-70, 4th Industrial Zone, Mashantou, Gongming Town,Shenzhen,China.


News
Home > News > Content

CNC Machining Parts Factory Tell You How To Keep The Aluminum Cutting Machine

CNC Machining Parts Factory Tell you how to maintain aluminum cutting machine?

How to maintain aluminum cutting machine? Let CNC Machining Parts Factory tell you.

1, CNC machining parts factory the daily need to check the aluminum cutting machine oil cup with or without oil, our company uses 20 # of the air pressure lubricating oil, should be kept seven full, to avoid the air compressor parts without lubricating oil and reduce the service life, check the pressure to keep 6 -7kg pressure to operate, the pressure is too large or too small to make the air compressor parts damaged, the machine's water filter with automatic row of water function, such as automatic drainage can not replace the water filter device, to avoid pipeline plot Water, affecting the machine work

2, CNC machining parts factory when the power is not used to keep the fuse switch off to ensure the safety of machines and personnel

3, CNC machining parts factory in the lubrication of the Department, the rod and the pressure of the rack with the Department, the shaft frame before and after the shaft, cylinder joints and into the material in the two with the wheel, with a weekly check, timely lubrication, to avoid stuck Loss of downtime

4, CNC machining parts factory cutting oil: the fuel injection group can spray CPC-R32 or saponification oil, air volume can be adjusted and left and right oil can be controlled separately using aluminum cutting oil or water-soluble cutting oil (saponified oil) 1:20, the ratio can not be too thin , To avoid excessive moisture caused by rust or stuck, need to check the amount of oil is sufficient daily, when necessary to add, full cooling can increase the life of the tool to reduce the aluminum cutting of the burr.

5, CNC machining parts factory to keep the work surface cleaning to ensure the accuracy of sawing

6, CNC machining parts factory the daily check the ducts for damage, if damaged please replace the new duct, to avoid the water leakage caused the machine can not work

7, CNC machining parts factory oil drums using CPC-R68 hydraulic oil, need to keep seven full, to ensure smooth operation of the cylinder, the first gas when the gas off the cover removed, open the oil tank above the oil cover, the oil added to seven After the full, close the oil cover, if the back cover can be.

8, CNC machining parts factory regular (super good once a week) to check whether the belt is over-wear, whether parallel, belt surface pressure is too loose or too tight.

9, CNC machining parts factory the operation of the pressure parts if the failure or no action of the situation, please replace the fault of the air compressor parts

10, CNC machining parts factory the machine's fuel injection cooling system using the injector, the use of siphon principle will be cooled to the nozzle of the cooling oil, cooling saw blade, in order to avoid obstruction of air parts and debris caused by failure.


Feedback
This is Shenzhen Runpeng Precision Hardware Co.,Ltd, If you have any questions, requests, etc., please feel free to use this form to contact us. All your comments and suggestions are welcome.
Contact us

Shenzhen Runpeng Precision Hardware Co.,Ltd

The contact:Susan Liao

Mobile:86-18925258235

Phone:86-755-29886925 

Fax:86-755-29886926

E-mail:sales@szrunpeng.cn

Web:www.sz-runpeng.com

Add:Building 69-70, 4th Industrial Zone, Mashantou, Gongming Town,Shenzhen,China.


Copyright ©Shenzhen Runpeng Precision Hardware Co.,Ltd All rights reserved.